Page 9 of 29
TM
dm10
Installation
Ensure you have read the Important Safety Instructions section on page 2 prior to
installing your HALCRO™ preamplifier. If you require assistance in the unpacking and
installation of your HALCRO™ preamplifier, please contact your dealer.
Unpacking
Undo the 4 fasteners at the base of each box. Then remove the upper part of the container
by lifting directly upwards, being careful not to rub it against the preamplifier. (To have
gained access to this manual you must have completed the above steps.)
Remove the material wrapping and foam pieces, then lift the preamplifier from the base
of the container. (It is recommended that the user take off all jewelry that may scratch the
unit and put on the white cotton gloves provided with the unit).
Remove the center piece of foam in base of transit case, to locate the remote control and
power cable.
Remove the covering from the unit. Please save it for later use.
Move the unit to its final location (
see Positioning
).
Important
Do not connect any cables as yet.
Safely store the packaging for future relocation of the unit and shipping if service is
required.
Positioning
The HALCRO™ dm10 preamplifier can be placed anywhere indoors. There is no need to
leave room around the unit to allow it to breathe. The dm10 does not generate significant
amounts of heat.
To ensure ultimate performance and to avoid potential safety hazards, place the unit on a
firm and level surface. When placing the unit on a shelf, be certain that the shelf and
mounting hardware can support the weight of the product.
