HAKO Scrubmaster B400 R, Руководство по эксплуатации

Страница: 97 / 170

Scrubmaster B400 R (7190)
97
Operation
3.6 Service information
In case problems occur with the machine, a four-digit service code is output in
the display panel in addition to the service indicator (tool key). The table below
explains the most important service codes. If the cause cannot be eliminated
and for all service codes not listed here, notify your authorised Hako dealer or
your Hako service workshop.
If the cause has been eliminated, the fault must be acknowledged via the key
switch OFF/ON.
Service
code
Fault Cause Remedy
1.2.5.1/
1.2.5.2/
1.2.5.5
Brushes stop Foreign particles between
brush and shaft
Inspect the brushes for for-
eign particles and remove
them if necessary
1.2.6.1/
1.2.6.8/
1.2.6.2
Brushes stop Foreign particles block the
brush
Inspect the brushes for for-
eign particles and remove
them if necessary
Brush not positioned
correctly in the holder
Actuate the brush decou-
pling system, contact the
service partner, if
necessary
1.2.6.3
Brush lift sys-
tem, brush and
suction turbine
have been
switched off
Foreign particles between
brush unit and machine
Inspect the brush unit for
foreign particles and
remove them if necessary
Brush unit stuck Release brush unit
1.4.6.1 Squeegee lift
system stops
Overload due to foreign
particles
Inspect for foreign parti-
cles and remove them if
necessary
Foreign particles between
squeegee and machine
Inspect the lift system for
foreign particles and
remove them if necessary
Squeegee jammed Make the squeegee
accessible
1.4.6.3/
1.4.6.4
Suction turbine
stops
Foreign particles in the
suction turbine
Notify Hako service
workshop
Faulty suction turbine
1.5.5.1 Fresh water
level not
displayed
Sensor error Notify Hako service
workshop