Hakko Electronics FN-1010, Инструкция по эксплуатации

Страница: 10 / 16

8
6-3-2 IR input
In addition to direct input of the offset value as described in “6-3-1 Direct input”, the offset value can also be set
using IR input.
Example) Using HAKKO FG-100B
6. OPERATION (continued)
3.
Press the [AUTO/SEND] button of the HAKKO FG-100B
and measure the temperature in AUTO HOLD mode.
When the measured temperature has been determined,
AUTO will change from blinking to lit.
4.
With the FG-100B in the condition
at the end of Step
3
,
press the [AUTO/SEND] button to send
the measured data to the IR receptor
of the FN-1010.
— Note —
For details on using the thermometer equipped with IR transfer function, refer to the instruction manual for the
thermometer being used.
1.
With the normal screen
shown, press the button.
2.
The offset input screen will appear.
In this state, the product is in standby.
5.
After the display shown below
appears, the new offset value will be
stored in the internal memory, and
heater control will start.
Temp Offset
00
℃
Temp Offset
Complete
Before
20℃
After
5℃
IR receptor
[AUTO/SEND] button
AUTO
AUTO
[AUTO/SEND] button
During temperature
measurement
Temperature
determined
Blinking
Lit