4
5. INITIAL SETUP
5-1 Iron holder
CAUTION
Be careful not to set the angle too high (close to vertical). Doing so will cause the grip to become hot.
Be careful not to set the angle too low. Doing so may let the soldering iron to fall out.
5-2 Handpiece
CAUTION
●
The tip gets hot. Use sufficient care when handling it to avoid getting burned.
●
When inserting or removing the tip, always be sure to switch the power off first.
●
Once the tip has been fully inserted into the handpiece, do not try to forcibly push it in more.
If the tip is not inserted correctly, “Sensor error” will be displayed.
1.
Loosen the two screws holding the iron receptacle (B5216),
adjust it to the desired angle, and retighten the screws to
secure it in place.
2.
Insert the cleaning wire (A1561) into the tip cleaner (FT401-81)
and attach the tip cleaner to the iron holder (FH210-81).
— Note —
It is possible to switch the left and right
positions of the iron receptacle
and cleaner.
Attach them in the locations
which make them easiest to use.
5-2-1 Inserting tip
1.
Place the tip in the tip insertion stand on the side of
the iron holder.
When putting the tip in, put it in the position matching
the shape of the tip end.
2.
Fix it by hand so that the soldering iron will not move
.
Slide the handpiece (FN1101-81) fully
onto
the tip.
Iron receptacle
(B5216)
Tip cleaner
(FT401-81)
Cleaning wire
(A1561)
Iron holder
(FH210-81)
For thin tips
For thick tips
*1 When a 5.2D-type tip is used, place
it here and then press-fit it into the
handpiece. Otherwise, a 5.2D-type tip
cannot be attached.
