Hakko Electronics FN-1010, Инструкция по эксплуатации, Страница: 8 / 16

6
6. OPERATION
CAUTION
●
At the time of shipment from the factory, the default temperature setting is 350°C.
●
When not using, place the iron in the iron holder.
— Note —
Load repetition count function and supplied energy calculation function are influenced by factors such as tip
shape, deterioration condition of tips, temperature setting, external environment and work size.
Please use values as reference.
Set power switch to ON.
When turning on the power switch initially,
it is necessary to set the date/time.
When the set temperature has been reached,
a buzzer will sound to indicate that the iron is ready to use.
6-1 Setting/changing the temperature
The temperature can be set or changed by the following steps. The settable temperature range is 50 – 450°
(120 – 840°F).
Input Time & Date
20 18 /01/01/00:00
1.
With the normal screen shown,
press the button. The menu
screen will appear. Select “Temp
Set” and press the button again.
3.
Following the same procedure as
in Step
2
, set the tens and ones
digits.
*2
After setting, press the button.
2.
The temperature setting screen
will appear.
Press the or button to set
the hundreds digit.
*1
After setting, press the button.
4.
The set temperature will be stored
in the internal memory, and after
the new temperature setting has
been displayed, heater control
will start.
Temp Set
Auto Cal
Auto Cal Info
Tip Info
Load Detection
Preset Temp
Offset Temp
350
℃
→
→
→
OFF
→
00
℃
Set Temp
40 0
℃
Set Temp
3 50
℃
400
400
℃
D24
*1 Values from 0 – 4 can be set. (In °F mode, values from 1 – 8 can be set.)
*2 Values from 0 – 9 can be set. (The range is the same in °F mode.)