Hakko Electronics FN-1010, Инструкция по эксплуатации, Страница: 9 / 16

7
6-2 Selecting a preset temperature
6-3 Setting/changing the offset
6-3-1 Direct input
The offset can be set or changed by the following steps. The settable offset range is -50 – +50°C (-90 – +90°F).
Example) When the set temperature is 400 ℃ and the tip temperature is 395 ℃, the difference between them is 5 ℃.
1.
With the normal screen
shown, press the button.
3.
Following the same procedure as
in Step
2
,
*1
set the tens and ones
digits.
*2
After setting, press the button.
2.
The preset selection screen will
appear.
Press the or button to select
the desired Preset No.
After selecting, press the button.
The selection will be stored in
the internal memory and after the
new temperature setting has been
displayed, heater control will start.
4.
The new offset value will be stored
in the internal memory, and heater
control will start.
Temp Offset
0 5
℃
Preset1
Preset2
Preset3
Preset4
Preset5
Preset Select
250
℃
300
℃
350
℃
400
℃
450
℃
400
400
℃
D24
*1 Values from 0 – 5 can be set. (In °F mode, values from 0 – 9 can be set.)
*2 Values from 0 – 9 can be set. (The range is the same in °F mode.)
1.
With the normal screen
shown, press the button.
2.
The offset input screen will appear.
Press the or button to select
blank (+) or – .
After selecting, press the button.
Temp Offset
00
℃