31 / 41
Hakki Pilke 35 Falcon
Translation
Version 10
Replacing and tensioning the out-feed conveyor belt
The instructions for tensioning and aligning the out-feed conveyor are presented in Section 4.6.
Replace the out-feed conveyor belt as follows:
1.
Pull out the pin locking the conveyor in place and lower the conveyor to the ground.
2.
Shut the machine down and disconnect it from its power sources.
3.
Move the belt joint to the start of the conveyor.
4.
Fold the conveyor, but do not place the belt support in the transport position. This will allow the belt to
hang loose.
5.
Disconnect the joint by opening the bolts.
6.
Remove the old belt.
7.
First, insert the new belt under the folded conveyor (bottom opening) from the end of the conveyor with
the plates facing downwards. Feed the belt in until you can pull it out from the other end of the conveyor.
Pull out a length of approx. 60 cm.
8.
Push the other end of the belt into the upper section of the folded conveyor (top opening) from the end
of the conveyor. Feed it in until you can connect the joint.
9.
Pull the excess belt to the start of the conveyor.
10.
Open the conveyor to the operating position, and tighten and adjust the belt.
The belt is at the correct tension when its middle section is raised approx. 15 cm when the conveyor is in the
operating position. An excessively tight belt may be damaged more easily, and it places unnecessary strain on
the conveyor bearings.
Replacing the out-feed conveyor plates
The out-feed conveyor plates can be replaced by disconnecting the bolt joints (3 x M8) fastening the plates and
replacing the plates with new ones. It is recommended that you move the belt into a position that puts the plate
to be replaced above the conveyor. Shut the machine down and disconnect it from the power source for the du-
ration of the procedure.
4.11. Lubrication
All of the firewood processor's lubrication points, which require Vaseline, have been labelled. Lubrication must be
conducted at the designated maintenance intervals. There are 10 lubrication points, presented in figures 30-39
below. In order to access all grease nipples, remove the bolts circled in Figure 35 (or loosen them enough to slide
the plate out) and remove the cover plate.
1.
Cylinder nipples of the saw drive end (2 pcs) in Figure 31 and Figure 32 (every 50 hours)
2.
Control shaft bearing nipples (2 pcs) in Figure 33 and Figure 34 (every 200 hours)
3.
Grease nipple for the in-feed conveyor drive roller Figure 35 (every 200 hours)
4.
Guard nipples (2 pcs) in Figure 36 and Figure 37 (every 50 hours)
5.
Grease nipple for the out-feed conveyor’s turning device in Figure 38 (every 50 hours)
6.
Grease nipple for the log measuring device in Figure 39 (every 50 hours)
7.
Motion booster sleeve
J
and bar in Figure 19 (every 200 hours)
Содержание 35 Falcon
Страница 32: ...32 41 Hakki Pilke 35 Falcon Translation Version 10 Figure 30 Figure 31 Figure 32 Figure 33 Figure 34 Figure 35...
Страница 33: ...33 41 Hakki Pilke 35 Falcon Translation Version 10 Figure 36 Figure 37 Figure 38 Figure 39...
Страница 36: ...36 41 Hakki Pilke 35 Falcon Translation Version 10 Figure 43 Figure 44 Figure 45 Figure 47 Figure 46...
