Hainbuch MANOK Plus, Руководство по эксплуатации

Страница: 95 / 108

MANOK plus
Maintenance
Order h49 7144.907-333 95
WARNING
Serious injuries caused by imbalance resulting
from incorrect reassembly!

The product components must be installed back
in the same position.

If necessary, mark out the relative positions of
components prior to disassembly.
NOTE
Damage to materials caused by incorrect Removal
of the product!

More extensive disassembly than shown on the
exploded drawing is prohibited.
3. Dismantle the product as shown on the exploded draw-
ing. Pay attention to the following during disassembly:

To remove the cover from the housing, the cover
fixing screws and the mounting block fixing screws
must be removed.

To remove the rocker, turn the actuating screw
clockwise until the actuating screw no longer en-
gages in the thread of the housing. When turning
the actuating screw, guide the rocker in a parallel
manner.
4. Clean all oil and grease residues off all components with
an ester-free, non-polar, soft, lint-free cloth and check
for visible signs of damage.
5. Assemble the product as shown on the exploded draw-
ing. Pay attention to the following during assembly:

Replace worn or damaged fixing screws.
 Tighten all fixing screws to the specified tightening
torque [see nomenclature and/or »Screw tightening
torques« chapter]. When tightening the screws, do
so evenly to prevent any distortion under load.

Only apply lubricant to the mechanical mating sur-
faces. Pay attention to notes about lubricants [see
»Use of lubricants« chapter].

Avoid too much lubricant on the locating face be-
cause this can cause face run-out errors.

Apply grease to the sealing elements [for example
O-rings, rectangular rings] and sealing surfaces.
Pay attention to notes about greases [see »Use of
lubricants« chapter].