1
Product Category
SMA-2 • Installation Guide
Overview
The Extron SMA-2 swivel mount adapter kit is used for mounting
select tabletop TouchLink Pro touchpanels. The assembly can be
rotated up to 360°, providing easy access for multiple users sitting
around a table. The provided set screws fix the exact angle of rotation
in each direction to prevent cable strain and tangling.
ATTENTION:
•
If the SMA-2 will be installed into fine furniture, it is best
to hire a licensed, bonded craftsperson to cut the access
hole and perform the physical installation so the surface
will not be damaged.
•
S’il est prévu d’installer le SMA-2 dans du beau mobilier,
il est préférable de faire appel à un artisan autorisé et
qualifié pour couper le trou d’accès et réaliser l’installation
de telle façon que la surface ne soit pas endommagée.
Step One — Prepare the Site
Choose a location for the SMA-2. The mounting site must be free of
obstructions above and below the table so that the touchpanel can
rotate without the cables getting tangled.
Step Two — Secure the Base Plate to the Table
1.
Before securing the base plate to the bottom of the table, use
the provided hex key to insert the set screws into the base plate.
Figure 1 shows how to position the set screws to limit clockwise and
counter-clockwise rotation. You must have at least one set screw to
prevent the cables from becoming tangled and strained.
Secure the set screw(s).
Figure 1.
Placing Set Screws (shown in red)
2.
Mark the position where the barrel of the mounting plate passes
through the table and drill a hole through the table that is 1-1/8"
(29 mm) in diameter (see figure 2,
1
). If needed, use the base plate
as a template to mark the position of the hole.
3.
Place base plate against the bottom surface of the table so that the
central hole of the base plate aligns with the hole in the table. Use
the threaded barrel of the mounting plate to help with the alignment.
NOTES:
•
Ensure the base plate is in the correct orientation with
the concave surface facing away from the table (see
figure 2).
•
Ensure the base plate is aligned so that the set screws
stop the rotation of the assembly as required.
SMA-2 Parts
Touchpanel mounting plate
with threaded barrel
Base plate
Swivel disk
Frictionless disk
Lock nut
#6-32 flat head screws (2)
#6-32 set screws (2)
#6 round head wood
screws (2)
The kit also includes a 1/16" hex key (not shown).
1-1/8"
29 mm
1
1
2
2
3
3
2
2
2
3
3
3
NOTE:
surface against the bottom of the table and
the concave surface facing out.
The base plate is oriented with the flat
Figure 2.
Secure the Baseplate to the Table
4.
Mark the position of the holes for the two mounting screws and drill
two pilot holes, diameter 7/64" (
2
).
5.
Secure the base plate to the bottom of the table with the two
provided #6 round head wood mounting screws (
3
).
