K00369 ADAPTER KIT
Installation Instructions
The K00369 kit is used for installing ice machines weighing less than 180 lb., Q-0280, Q-0450, Q-0600, Q-0600C, Q-
0800C, Q-1000C, Q-1400C, S-0300, S-0450, S-0500, S-0600, S-0600C, S-0850C, and S-1000C, on a Manitowoc S or B-
970 bin.
1.
Note: Bin must be level before installation of ice machine.
A.
Remove the foam tape from the front and sides of the bin where the support angle will be located. Use the front
angle to reference the areas where the tape should be removed.
B.
Place the support angle on the front edge of the bin and position as far forward as possible.
C.
Locate the four pieces of the 2” long, 3/4” wide foam tape in the front corners, as shown.
D.
Place the adapters on bin, as shown. Make sure the two holes from the support angle and adapters are aligned on
the side.
E.
Using the adapters as templates, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in bin.
Warning: Do not drill through the interior liner.
Attach each adapter with three 10-24 x .500” screws
provided.
F.
Apply foam tape to the front and back of the bin between the adapters. Note: All other required foam tape comes
preassembled with the support angle and adapters.
G.
Note: It is recommended to RTV intersections and along the inside edge of the foam tape to prevent water
tracking.
2.
Refer to ice machine installation manual for ice machine installation procedures.
Adapter
Adapter
.75” Wide Foam Tape
INSTALLER: It is recommended
to RTV intersections and along
inside edge of foam tape to
prevent water tracking
Adapter
#10-24 x .50”L
Screws Typ
Support Angle
.75” x 2.00”L Foam Tape
Typ both front corners
.75” Wide Foam Tape
