Parts and Functions
Operation
CAUTION
Before opening the front grille, be sure
to stop the operation and turn the
breaker OFF.
Do not touch the metal parts on the
inside of the indoor unit, as it may result
in injury.
Air outlet selection switch
Operating
mode
Situation
Blowing pattern
Cool
mode
Heat
mode
At start or when air
temperature is low.
So that air does not come
into direct contact with
people.Air is blown upper
air outlet.
At start of operation
or other times when
the room is not fully
cooled.
Air is blown from the upper
and lower air outlets for
high speed cooling during
Cool mode, and for filling
the room with warm air
during Heat mode.
So that air does not come
into direct contact with
people, air is blown
upper air outlet, room
temperature is equalised
When the room has
become fully cool.
Air conditioner automatically decides the appropriate
blowing pattern depending on the operating mode
and situation.
During Dry and Fan mode, so that cold air does not
come into direct contact with people, air is blown upper
air outlet.
Regardless of the operating mode or situation, air
blows from the upper air outlet.
Use this switch when you do not want air coming
out of the lower air outlet. (While sleeping etc..)
Base Operation
temperature is below 16 C, do not use it in the
o
Test operation:
Use this switch in the test operation when the room
normal operation.
your finger from the switch: the cooling
Continue to press the test operation
switch for more than 5 seconds. After
you hear the "Pi" sound twice, release
operation starts with the air flow speed "Hi".
Emergency operation and test operation
Pi Pi
At times other than
below.
(Normal time.)
Test operation switch is the same as emergency switch.
In DRY mode, when room temperature becomes lower than
temp.2 C, unit will run intermittently at LOW speed
o
regardless of FAN setting.
Under the mode of auto operation, air conditioner will automatically
select Cool or Heat operation according to room temperature.
When FAN is set to AUTO the air conditioner automatically adjusts
the fan speed according to room temperature.
In FAN operation mode,the unit will not operate in COOL or HEAT
mode but only in FAN mode, AUTO is not available in FAN mode.
And temp. setting is disabled In FAN mode, sleep operation is not
available.
In HEAT mode, warm air will blow out after a short period of the
time due to cold-draft prevention function.When FAN is set to
AUTO, the air conditioner automatically adjusts the fan speed
according to room temperature.
AUTO
COOL
DRY
HEAT
FAN
Operation
Mode
Remote
Controller
Note
Press FAN button. For each press, fan speed
follows:
Remote controller:
Press
button
Every time the button is pressed, temp.setting
increase 1
o
C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
decrease
1
o
C,if kept depressed, it will
decrease rapidly
Select a desired temperature.
4.Fan speed selection
3.Select temp.setting
Air conditioner is running under displayed fan speed.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
1. Unit start
Press ON/OFF on the remote controller, unit starts.
/
Remote controller
changes as
1
4
3
3
LOW
MED
HI
AUTO
2. Select operation mode
2
COOL button:Cooling mode
HEAT button: Heating mode
DRY button: Dehumidify mode
Display
circulated
Domestic air conditioner
System configuration
193