<;
4=5 Nmcnnq hmrs`kk`shnm
Xo bear the unit3 in the place with existing
ceiling3 use the foundation boltB while in the
place with new bulit ceiling3use the built4in bolt3
embedded bolt or other parts supplied on
field5Gefore installation3 adjust the distance to
the ceiling5
TZH pipe
7{< mm
/7{759+0
Wuspending bolt
Q87 nut
Qain unit
Q87 washer
Q87 spring washer
Manging bolt Q87
Mole4in anchor
Mole4in plug
Nnsert
Honcrete
Nf necessary3 prepare all the needed installation and checking hole on the ceiling /with existing ceiling0
Gefore installation3 prepare all the pipes /refrigerant3 drainage0 and wire /wire controller connection
wire3 indoor and outdoor unit connection wire0 connected with indoor 3 so that after installation3 they
can be immediately connected with indoor5
Hut the opening on the ceiling5 Qaybe it needs to strengthen the ceiling to keep the ceiling even and
flat and prevent the ceiling from vibration5 Kor details3 please consult the builder5
Xtrodmchmf anksr hmrs`kk`shnm
/Yse Q87 screw bolt0
Nmrs`kk`shnm ne hmcnnq tmhs
Kix the indoor unit to the suspending bolts5
Nf necessary3 it is possible to suspend the unit
to the beam3 etc5
Iirectly use the suspending bolts instead of
the suspending screws5
[hen the dimensions of main unit and ceiling holes does not match3 it can be adjusted with the slot holes
of hanging bracket5
Snsd
Fcitrshmf sn sgd gnqhynm
Fdjust the horizon with a gradienter or by the following
methodA
Qake adjustment so that the relation between the lower
surface of the unit and water level in the hose becomes
what is in the figure5
Ynless the adjustment to the horizon is made properly3
failure of the float switch may occur5
Tiping side
[ater level
make the piping side slightly lower5
Wupply water
Содержание MRV II AV08NMVERA
Страница 112: ...112 5 Wiring connection among units ...