;;
FG8?9{FG;?9A
85Spen the grille
Tress +TYWM+ button3 the inlet grille will open automatically /there are hooks on both sides of inlet grille3see figure ;05
95Spen the two hooks3see figure <5
hooks on both sides
hooks
press the button
2541
/figure ;0
air filter
pull down the white rod to take out the filter
;5Vemove air inlet grille3see figure >5
/figure <0
/figure =0
/figure >0
:5Vemove the air filter3see figure =5
G5Srnament panel installation on the indoor unit
Nnstall the panel as the direction in the
figure3if not3 there will be air leakageB
also the swing and receiver can not
connect successfully5
Kasten the two temporary screws and the other two screws5
Kirstly fix the panel with screws temporarily5
Honnect the motor3 the communication wire and the power cable3 and
check if the wiring is correct with a controller5 Ffter confirming the unit
can run normally3 install the air inlet grille3 corner cover3 etc5
80FG7@9{FG8=9A
90FG8?9{FG;?9A
Nnstall the ornament panel
Whown as figure 83 put the swing motor on the ornament panle and the pipe on the unit at the same position3
then install the ornament panel on the indoor unit5
a5 Tlace the holding ring on swing motor opposite side temporarily on hooks of the indoor unit5 /9 pcs0
b5 Tut the other two holding rings on the hooks at both sides of the indoor unit temporarily5 /Tay attention not to
push wires of swing motor into seals05
c5 Wcrew in all ; screws under holding ring for about 8<mm5 /Tanel will rise05
d5 Fdjust the ornament panel as per procedure d to cover the ceiling opening5
e5 Xighten screws to reduce the thickness of seals between ornament and indoor unit to <4?mm5
remote receiver
Содержание MRV II AV08NMVERA
Страница 112: ...112 5 Wiring connection among units ...