Hagie STS14, Руководство оператора

Страница: 39 / 127

IV.
OPERATING SYSTEMS
4.16
B. HYDROSTATIC DRIVE SYSTEM
Operating The Engine
FIG. 4.16-1
Pre-operational Checks Section Reference
1. Check the engine oil level. Do not oper-
ate when oil is below the low mark on
the dipstick.
2. Check the coolant level in the radiator
and the coolant overflow reservoir.
3. Check the hydraulic oil reservoir level.
4. Check the cooling air intake screen
5. Check the Filter Minder®.
6. Drain fuel/water separator.
7. Check engine drive belt.
8. Drain any water out of the air tank daily.
9. Check for any oil or fuel leaks and correct them if needed.
Start engine from operator’s seat only. When running engine
in a building, be sure there is adequate ventilation.
7.6
7.8
7.6
7.9
7.10
7.12
7.17
7.22
NOTE:
Cold oil may not flow
in quantities adequate
to prevent pump
cavitation.
BATTERY DISCONNECT-
The STS is set up with a battery dis-
connect safety device (fig. 4.16-1). This device is located on the left side
of the rear frame cross tube. When the key is turned to the OFF position
the electrical circuit is broken therefore render-
ing the machine unable to start. Do not use this
device as a safety when working on the electri-
cal system– disconnect the negative battery
cable before servicing.
This device is also used as an anti-theft
safeguard. Keep the key in a safe place, out of
the machine when it is not in use.