Hagie STS14, Руководство оператора

Страница: 105 / 127

VII.
SERVICE AND MAINTENANCE
H. TOE– IN
7.20
GAUGING TOE-IN–
To correctly gauge toe-in, phase the cylinders first (page 4.22).Then use a tape
measure placed at one-half the height on the front center seam of the front tire compared to the same meas-
urement of the rear of the front tire (subtract the front measurement from the rear measurement— it must be a
positive number). Correct toe-in should fall between one half and three quarters of an inch.
Toe-in is preset at the factory and should not have to be adjusted unless the steering cylinders are re-
moved.
Difficulty steering one way versus the other or “darting” during operation, may indicate incorrect toe-in and
may require adjustment.
EXAMPLE OF CORRECT TOE-IN FOR A
MACHINE WITH 120 INCH TREAD WIDTH.
(MUST HAVE ½" TO ¾" TOE-IN.)
119¾”
120¼”
NOTE:
See next page for instructions on adjusting
toe-in. See also page 4.22 for information
on recalibrating self-centering cylinders.
EXAMPLE OF CORRECT REAR TOE-IN FOR A
MACHINE WITH 120 INCH TREAD WIDTH.
(MUST BE STRAIGHT.)
120”
120”
FIG 7.20-1