Information for electricians
Manual commissioning/device setting
5.3
Manual commissioning/device setting
Setting mode
Setting
Colour of the status LED (5)
Mode 1
Adjusting the sensor unit installation height
Lights up white
Mode 2
Establishing radio connection
Flashes purple-blue
Mode 3
Calibrating cooker type
Flashes yellow-green
Mode 4
Setting and testing AUX connection
Flashes white (normal AUX mode)
Flashes red (reversed AUX mode)
Table 5: Setting modes
Manual commissioning is only required when the cooker has been replaced, the cooker dimensions
and the mounting height of sensor unit deviates from the standard values (Bild 8) or there are frequent
false alarms.
Manual commissioning is performed via four setting modes on the sensor unit:
The setting modes can be changed successively or individually.
1
Keep the operation button (2) pressed for 5 s.
Setting mode (1) is active. Status LED (5) lights up white.
2
Press the OK button (3) repeatedly until next setting mode is reached.
The Status LED (5) signals the set mode in the appropriate colour.
Setting mode 1: Adjusting the sensor unit installation height
Caution
It is only possible to switch to the next installation height!
The sensor unit can trigger false alarms.
l
The manual setting mode is exited automatically after a single adjustment of the instal-
lation height.
The installation height of the sensor unit can be used using the table (Tab. 4).
The status LED (5) lights up white.
l
Press operation button 1 (1) briefly.
The installation height of the sensor unit is increased by 5 cm and the status LED (5) flashes in the
colour as stated in table (Tab. 6).
Check the newly-set installation height.
OR:
l
Press operation button 2 (2) briefly.
The installation height of the sensor unit is reduced by 5 cm and the status LED (5) flashes in the
colour as stated in table (Tab. 6).
Check the newly-set installation height.
18