Hach Ultra ORBISPHERE 510, Руководство оператора

Страница: 60 / 144

54 of 138 Measurement Menu - Orbisphere 510/511/512 Analyzers
Operator Manual
ORBISPHERE
Note:
Data stored in volatile
memory are lost when
instrument is off, non-
volatile memory is
permanent. In case of an
accidental power off event,
the instrument resumes
measurement storage after
the last measurement
stored in flash.
RAM time (volatile memory): Delay in seconds
between two recordings of measured data.
FLASH time (non-volatile memory): Delay in seconds
between two data file transfers from volatile memory
into non-volatile memory. The last data file erases the
previous one. This field is only available if the Auto
save in flash box is checked.
Save in flash now: Press this button to store
measurement data in flash (non-volatile memory)
immediately. After pressing this button, press OK to
initiate the process. A warning screen appears
informing you that the operation can take up to 30
seconds. Press Yes to continue with the process, or
No to abort.
⌧
Auto save in flash: Check this box to save the
measurements in flash (non-volatile memory)
automatically. Measurements are saved at regular
time intervals as defined in the FLASH time box.
Start logging measurement: Store once mode. Starts
and stops the measurement recording session.
Measurement recording is stopped when the buffer is
full.
Purge data: Clear all data for all channels in the
volatile and non-volatile memories
Open data 1 2 or 3: Opens the table showing the
measured values which are stored in the volatile
memory (RAM).
Use the scroll bar at the right to move to another data
range (the id range will be shown in the title bar).
The page number being viewed and the total number
of pages are shown at the bottom (page 1 of 27 in the
example left).
Use the keys at the bottom to move directly to the first
page, previous page, next page or last page.
Note:
If TPO or TPA calculation is enabled, a ”TPO data” or a
”TPA data” button will be available underneath the “Open
data” button described above. Pressing this button will
display the TPO or TPA calculated data in a screen
similar to that for standard data.