Hach Ultra ORBISPHERE 510, Руководство оператора

Страница: 117 / 144

Orbisphere 510/511/512 Analyzers - Services Menu 111 of 138
Operator Manual
ORBISPHERE
11.1 Sensor Diagnostics
11.1.1 Calibration Timer
11.1.2 Service Timer
11.1.3 Null Current Measurement (EC sensor only)
The instrument can automatically remind the user when
the next sensor calibration is due.
• Select measurement channel.
Select enable and enter a delay in days.
The display shows the current instrument date and
time, next calibration due date and time, and the
remaining days.
The next calibration date is updated when the sensor is
calibrated. The event “Cal. required” is generated when
the delay has elapsed.
The instrument can automatically remind the user when
the next sensor service is due.
Select enable and enter a delay in days. This should
be validated by a level 3 user.
The display shows the current instrument date and time,
the next sensor service due date and time, and the
remaining days.
The next service date is updated when the button
“Service done” is pressed after a service. The event
“Service required” is generated when the delay has
elapsed.
The sensors attached to your instrument will require
periodic servicing and maintenance. For more information
on this, please refer to the manual(s) delivered with the
sensor(s).
This is a diagnostic tool for Hach Ultra technicians. This
feature will allow checking the ability of the EC
measurement board to measure a null current. This ability
is very important to measure traces of gas.
Press start to measure the current generated at the
sensor.
- The measurement board opens a contact in order to
measure a null current instead of the sensor current.
- The window displays the current measured, and
information as to whether the value is acceptable or
not.
If test fails please contact your Hach Ultra representative.