Haas Bar Feeder, Руководство оператора

Страница: 18 / 56

Read Before Operating
2
Operation Safety:
DANGER: Incorrect setup of the Bar Feeder or spindle liner tubes can cause the
workpiece or rotating parts to be ejected with lethal force, which can
also destroy the machine(s).
• Do not attempt to operate the Bar Feeder until you have received operation and
safety training.
• Keep your body, limbs, and foreign objects out of the machine during operation.
• Make sure that your setup is correct before automatic operation.
• The Bar Feeder is automatically controlled and may start at any time.
• Warn nearby people that an automatic machine is in operation.
• Do not operate the lathe or the Bar Feeder with the door open.
• Immediately replace worn or broken Bar Feeder components or spindle liners.
• Do not modify the Bar Feeder in any way.
• Do not use the Bar Feeder beyond the recommended speed or material
capacity limits.
• Do not use the Bar Feeder without a correctly sized spindle liner installed in the lathe
spindle.
• In the event of vibration or unusual noise, immediately stop the lathe spindle. Do not
operate the machine again until you find and correct the condition that causes the
vibration or noise.
• Do not attach dead stops, bar pilot bushings, or anti-vibration collars to the body of
the rotating union (chuck closing cylinder) of the lathe. Violent, catastrophic failure of
the rotating union can occur at high spindle RPM if attached devices cause damage
to the rotating union.
• Do not operate the spindle while the bar material is unclamped.
• Do not operate the spindle if the bar material extends out of the spindle liner.
• Do not start or continue a machine cycle unless you are certain of the
part-off allowance.
• Damage from incorrect use is not covered under the machine warranty.
• There are no user serviceable parts inside the machine. Contact your dealer for
approved service.
96-8913A.book Page 2 Monday, May 18, 2015 7:55 AM