2
96-5047 rev L June 2005
1.2 L
IMITATIONS
The control and table are described as a “semi-fourth axis”. This means that the table cannot do simultaneous
interpolation with other axes. Linear moves or spirals can be generated by having an axis of your mill move at
the same time the rotary table moves (see the "Programming" section for details).
1.3 M
ACHINABLE
P
ART
S
IZE
The HRT series was designed for positioning and continuous milling of medium to large size parts. When
selecting a rotary table, the size of a typical workpiece and fixture must be considered and the size of the
rotary table should be matched to the expected loads. As a general rule, the diameter of the part should not
exceed the diameter of the rotary table platter. Also, the combined part and fixture weight should not exceed
the weight of the rotary table. However, these are only guidelines. A part with a diameter larger than the platter
diameter or a long overhung and unsupported part might require that the weight be less than the weight of the
rotary table. Likewise, if the part is well supported (i.e. tailstock or pillow block), and the fixture and support
have less than 0.003" T.I.R, then the weight might be able to be more than the rotary table weight. Common
sense and good fixturing technique will generally make it possible to machine larger parts.
The HRT210SHS Table was designed for lighter size parts which may require numerous tool changes and
indexes, so the speed is important to reduce the cycle time. It has no brake, so this will also be a limiting
factor to the size of the part. Maximum part diameter is 8.00” and maximum part weight should not exceed 40
lbs.
1.4 F
EATURES
RIGID DESIGN
Large bearing surfaces support heavy cutting forces on large or small parts.
CLASS 30 GREY IRON
For added damping capacity
QUICK REPLACEMENT CONDUIT
For faster replacement and shorter downtime.
PRE-LOADED ANGULAR CONTACT BEARINGS
For better reliability and less wear.
HARDENED AND PRECISION ROTARY GROUND PLATTER
Ensures more accurate part machining.
CNC HOBBED WORM GEAR*
For high accuracy.
DEEP TOOTH ENGAGEMENT
For gear set; designed to provide greater accuracy and continuous milling capacity.
ALUMINUM BRONZE WORM GEAR*
For long life.
HARDENED AND GROUND WORM GEAR*
Made from 8620 chromium-nickel-molybdenum steel, hardened to Rc 60.
AIR BRAKE*
Built-in air brake with 100 to 1500 ft.-lb. of holding torque @ 100 PSI. (Except HRT210SHS)
Содержание HRT 160
