10
96-5047 rev L June 2005
2. SETTING UP THE HAAS ROTARY TABLE
2.1 G
ENERAL
S
ETUP
1.
Fill out the warranty card and mail it in. (Very Important).
2.
Place the indexer on your machine. Route the cable from the table such that it avoids tool chang-
ers and table edges. Slack must be provided for your machine's movements. If the cable is cut, the
motor will fail prematurely. Secure the HRT Rotary Table to your machine’s T-Slot table as shown
below.
NOTE: The HRT 160, 210, 450, and 600 Rotary Tables can be secured as shown:
1/4-20UNC
SHCS (4)
Toe-Clamp
Assembly (2)*
Remove Top Cover
to Access Toe-Clamp
Pockets
1/2-13UNC T-Nuts, Studs,
Flange nuts and Washers*
Clamping Tool
Assembly (2)
Bottom View
of Casting
1/2-13UNC T-Nuts, Studs,
Flange Nuts, and Washers
*
Toe Clamp
Assembly
*
1/2-13UNC T-Nuts,
Studs, Flange nuts,
and Washers
*NOTE: Toe-Clamp Fasteners are not supplied.
*Standard stud mounting, front and
rear For extra rigidity, use
additional Toe-Clamps.
NOTE: The HRT 310 can be secured as shown:
3/4-10UNC X 8”
SHCS (4)
7.875”
0.781”
Thru
C’Bore 1.188
X 0.80 DP
1”
Req.
1/2-13UNC T-Nuts,
Studs, Flange nuts
and Washers
Fixture Plate
3.
Connect the indexer to run as a full-fourth or semi-fourth axis. See the following figure. For full-
fourth axis, the indexer is connected directly to the HAAS mill control at the connector labeled “A-
Axis”, and is the desired connection.
Содержание HRT 160
