Haas+Sohn HRT 160, Руководство оператора и по обслуживанию

Страница: 26 / 65

25 96-5047 rev L June 2005
A) Main POWER switch to turn the unit on (back panel).
B) CYCLE START begins a step, stops a continued operation, inserts a step, or turns the servo on.
C) EMERGENCY STOP turns off the servo when on and aborts the step in progress.
D) JOG causes the servo to move in either the forward or backward direction at a rate defined by the last
numeric key pressed.
E) Load meter LED. If LEDs are illuminated continuously during a low feed rate or when stationary, the
following conditions apply:
HIGH LOAD: Indicates overload level, excessive load or workpiece support misalignment. Hi-LoAd or Hi
Curr alarms may occur if not corrected. (See "Troubleshooting" section)
OVERLOAD: Indicates 2x overload level, excessive load or workpiece misalignment. Hi LoAd or Hi Curr
alarms will occur if not corrected. Damage to motor or table may result. (See "Troubleshooting" section)
NOTE: It is normal for the LEDs to be illuminated during a rapid movement or high duty
cycle.
F) ZERO RETURN causes the servo to return to HOME position, search for mechanical HOME, delete a step,
or move forward to the mechanical offset.
G) ZERO SET clears the entered data, resets program to 0, or defines the present servo position as HOME.
H) MINUS KEY selects negative step values or Prog/Upload/Download functions.
I)
STEP SCAN scans step numbers from 1 through 99.
J) DISPLAY SCAN scans the display to show either Position, Step Angle, Feed Rate, Loop Counts, or G
Code.
K) MODE / RUN PROG switches from RUN mode to PROGRAM mode (blinking display).
L)
Data entry keys and jog speed selection.
M) Displays show current data, i.e., a current spindle position of 180.
N) Indicates what data is being displayed. Either P, F, L, blank, or G for Position, Feed Rates, Loop Count,
Step Angle, or G Code.
O) Present step number. Step numbers 1 to 99 are available. Also displays errors at turn on.