6-1
6
Installing hardware options
If you are installing multiple hardware options, read their installation procedures and identify similar
steps to streamline the entire installation procedure.
Installing the security bezel
1.
Press the right edge of the security bezel into the groove in the right chassis ear on the server.
See callout 1 in
2.
Press the latch at the other end, close the security bezel, and then release the latch to secure
the security bezel into place. See callouts 2 and 3 in
.
3.
Insert the key provided with the bezel into the lock on the bezel and lock the security bezel (see
callout 4 in
). Then, pull out the key and keep it safe.
CAUTION:
To avoid damage to the lock, hold down the key while you are turning the key.
Figure 6-1 Installing the security bezel
Installing SAS/SATA drives
Guidelines
The SAS/SATA drives are hot swappable. If you hot swap an HDD repeatedly within 30 seconds, the
system might fail to identify the drive.
If you are using SAS/SATA drives to create a RAID array, follow these restrictions and guidelines:
•
To build a RAID array (a logical drive) successfully, make sure all drives in the RAID array are
the same type (HDDs or SSDs) and have the same connector type (SAS or SATA).
