H3C S12500G-AF Series, Руководство по установке

Страница: 44 / 105

4-11
Figure4-10 Installing a fan tray (S12504G-AF switch)
Installing power modules
The power module slots are located on both sides of the rear panel.
The installation procedure is similar for DC and AC power modules.
To install a power module:
1. If a filler panel is installed in the slot, remove the filler panel first.
As shown in Figure4-11 , use your forefinger to hold the filler panel through the hole and pull out
the filler panel along the guide rails.
2. Correctly orient the power module.
If you install the power module in a left power module slot, make sure the latch is above the
handle. If you install the power module in a right power module slot, make sure the latch is
below the handle.
3. Holding the handle of the power module with one hand and supporting the bottom of the power
module with the other, slide the power module along the guide rails into the slot until you hear a
click.
Figure4-11 Removing a filler panel (S12508G-AF switch)
3
3
3
3
2
1