H3C S12500G-AF Series, Руководство по установке

Страница: 39 / 105

4-6
Figure4-5 Removing the protection box from the fabric module (S12508G-AF fabric
module)
2. As shown by callout 1 in Figure4-6 , release the ejector levers by pressing the spring clips for the
ejector levers.
3. Correctly orient the fabric module. Hold the fabric module front panel near the ejector levers
with one hand and support the module bottom with the other. Place the module bottom on the
guide rails at the chassis bottom. Align the fabric module with the target slot and insert it into the
slot along the guide rails. See callout 2 in
Figure4-6 .
Keep the module parallel to the slot to avoid touching other components in the chassis.
4. Continue to push the fabric module until the brakes on its ejector levers touch the slot edges
tightly.
5. As shown by callout 3 in Figure4-6 , simultaneously rotate the ejector levers inward until the
spring clips lock the ejector levers in place and the fabric module is completely seated in the
slot.
Figure4-6 Installing a fabric module (S12508G-AF switch)
Installing a filler panel in a fabric module slot
IMPORTANT:
Captive screws are required to install a filler panel in a fabric module slot. As a best practice, fasten
a captive screw to a torque of 5.5 kgf-cm (0.54 Nm).
1
2
3
2
1
3
2