H3C MSR 30-16, Руководство по установке

Страница: 88 / 97

88 C
HAPTER
6: H
ARDWARE
M
AINTENANCE
Installing CF Card Install the CF card following these steps:
Step 1: Push the ejector button into the slot completely, and make sure it only
springs out with outside force.
Step 2: Press the CF card into the slot in correct orientation, and make sure it only
pops up with outside force.
Figure 77 Press the CF card into the slot
n
Make sure the CF card with correct application program is properly installed in the
slot; or, the system cannot boot.
Removing CF Card Remove the CF card following these steps:
Step 1: Check the CF card LED to make sure it is not blinking, and then proceed.
Step 2: Press the spring button to release the internal spring clip, making the card
out of the slot a little.
Step 3: Push the spring button hard in the orientation shown in the figure below,
and the CF card on the right pops up a little. Take it out.
Figure 78 Press the spring button to make the card spring out
c
CAUTION: Do not insert or remove the card when the router is booting or the LED
is blinking to avoid hardware damage.
Replacing a Memory
Module
n
The memory module on the MSR 30-11 is irreplaceable.
This section describes how to replace a memory module. See Figure 79.