H3C MSR 20-20, Руководство по установке

Страница: 38 / 73

38 C
HAPTER
4: S
TARTUP AND
C
ONFIGURATION
the WAN. For the dial-up interface, the user also needs to configure DCC
parameters. Then, configure the link layer protocol encapsulated on the interface
and the related operating parameters according to the WAN type.
Step 4: Configure the IP addresses or IPX network numbers of all the interfaces on
the router according to the division of the subnets.
Step 5: Configure the routes. If it is necessary to enable a dynamic routing
protocol, the user should configure the related operating parameters of the
protocol.
Step 6: If special security is required, perform the security configuration for the
router.
Step 6: If special reliability is required, perform the reliability configuration for the
router.
See H3C MSR 20/30/50 Series Routers User Manual for the configuration details of
the protocols or functions of the router.
Basic Configuration
Procedures
Command Line Interface Characteristics of the command line interface
The command line interface of MSR 20 Series Routers provides a number of
configuration commands, which can be used to configure and manage the router.
The command line interface has the following characteristics:
■
Performs the local configuration through Console port
■
Performs the local or remote configuration through telnet command, which
can be used to directly log on and manage other routers.
■
Users can enter “?” anytime to get online help.
■
Provides network diagnostic tools, such as Tracert and Ping, to quickly diagnose
the availability of the network.
■
Provides all kinds of detailed debugging information to diagnose network
faults.
■
The command line interpreter adopts fuzzy search for the keywords of the
command. If the user enters the conflict-free keyword for a command, the
command will be interpreted accordingly. For example, for a
display
command, the user can just enter dis .
Command line interface
The command line interface of H3C MSR 20 Series routers provides plenty of
configuration commands. All the commands are grouped in system view. Each
group corresponds to a view. The user can use these commands to switch
between different configuration views. In general, only certain commands can be
executed under a particular view. But some common commands (such as
ping
and display current-configuration ) can be executed in all views.