H.264 4-CH SCW-7704, Руководство пользователя, Страница: 34 / 74

- 34 -
Following is a brief description for each item and its specific operations:
„ Duration – response duration to define at most how long (in seconds) the Alarm Out relay and
the Buzzer will keep being triggered after motion is detected for this camera. However, the
Alarm Out relay and the Buzzer will be reset immediately once the camera returns to normal.
Press
+/- buttons to adjust the value (3-60 seconds, discrete).
„ Goto Preset – to define the preset position to go to if motion is detected and this camera is a
PTZ camera. For more details about preset locations, please refer to Chapter 7 PTZ Control .
„
Pre-record – to define how long before motion is detected this camera shall be intensively
recorded at Pre-record IPS. Press
+/-
buttons to adjust the value (0-10 seconds, discrete).
Please note that the actual pre-record time may be shorter than the value set if the total size of
the pre-record pictures exceeds the pre-record buffer size of the system.
„ Post-record – to define how long after motion is detected this camera shall be intensively
recorded at Event Record IPS. Press +/- buttons to adjust the value (0 second - 60 minutes,
discrete).
„ Alarm Out – to define which Alarm Output will be triggered when motion of this camera is
detected. Press +/- buttons to select none (N/A) or one of the Alarm Outputs (1-2).
„ Buzzer – to activate the internal Buzzer or not when motion of this camera is detected. Press
ENTER or +/- to check/uncheck this item. The default setting is “
ˇ
” - checked.
„ Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this item. The
default setting is “
ˇ
” - checked.
„
Screen Message – to display the event message on the screen or not. Press
ENTER
or
+/-
to
check/uncheck this item. The default setting is “
ˇ
” - checked.
„ E-mail – to send the event e-mail to remote station or not. The e-mail will be sent to the
predefined receivers when the event is triggered. Press ENTER or +/- to check/uncheck this
item. The default setting is “
–
” - unchecked.
„ Detection Settings.. – used to setup the motion detection settings, including detection area and
sensitivity, when motion is detected for this camera. Press ENTER in Settings.. to call up
Motion Detection Setup (as shown) for this camera. In Motion Detection Setup, the video area
is divided into many small grids, and the area with transparent grids is the area which will be
detected for motion, while gray grids not detected for motion. Besides, there is a (green) Mask
window.
SCW-7704 User Manual
SCW-7704 User Manual