TLC2100SHD Operating Instructions
Document 900.0060 Rev 1.01
53
C
Warning Codes
Digital Display Codes
An Error annunciator in the Digital Display displays for the following events:
•
Error 1 - Cylinder Lock
•
Error 2 - Mecha Lock-1
•
Error 3 - Mecha Lock-2
•
Error 4 - Reel Lock-1
•
Error 5 - Reel Lock-2
The Warning Data may be displayed on the monitor by pressing STOP, DOWN and
H-POS when in a menu. A typical Warning Data line displays as follows:
121 091203 133445 CYRD21
•
The left column displays the number of times the failure occurred. A
1
means
once, a
0
means twice. A line will record only one or two failures. In the example
above, the failure occurred once. The system will not go into the ERROR mode
unless it gets the same error twice.
•
Moving to the right, the next two columns display the number of event (from 0 to
99). The display will list the first warning and the last eight warnings. In the example
above,
21
is the 21st event.
•
Moving to the right, the next six columns display the date on which the warning
occurred. In the example above, the date is September 12, 2003 (09/12/03).
•
Moving to the right, the next six columns display the time in a 24-hour format
(hours-minutes-seconds). In the example above, the time is 1:34:45 PM.
•
Moving to the right, the next two columns display the Warning Data code. See
Warning Data Codes
for an explanation of the codes. In the example above, these
columns display
CY
. As listed in the Warning Data chart,
CY
stands for Cylinder
Lock.
•
Moving to the right, the next two columns display the Status Code. See
Status
Codes
for an explanation of the codes. In the example above, these columns display
RD
. As listed in the Status chart,
RD
stands for REC (Record). In other words, the
warning occurred while in RECORD mode.
•
Moving to the right, the next column displays the Tape Speed Code. See
Tape
Speed Codes
for an explanation of the codes. In the example above, this column
displays
2
. As listed in the Tape Speed chart,
2
” stands for A24 or A30.
Note Perform a System
Reset or power cycle unit
by disconnecting AC
power to clear the Error
Message. One of these
two actions must be
performed to access the
Main Menu.
Содержание TLC2100SHD
