Gyyr TLC2100SHD, Руководство по эксплуатации

Страница: 17 / 78

TLC2100SHD Operating Instructions
Document 900.0060 Rev 1.01
1
1
Getting Started
Introduction
If you have never used a timelapse recorder system before, this section explains what
you need to do to get started.
In addition to your timelapse recorder, you need the following equipment:
• A video camera
• A monitor
• Cables for the camera and monitor (typically these are coax cables with BNC
connectors)
• A T-120 or T-130 VHS video tape. Silent Witness recommends the following
brands of tape: Gyyr, BASF, Maxell, and TDK
• Power sources for the VCR, camera, and monitor
Before connecting any piece of equipment to a power source, make the following
connections:
• Connect the camera to the VCRs Video In connector
• Connect the monitor to the VCRs Video Out connector
• Plug in all of your equipment to their power sources. This VCR unit connects into
a 120 VAC wall outlet.
• The very first time you power up your VCR, perform a Master Reset. The
procedure for performing a Master Reset is on the detachable
STOP! page at the
beginning of this guide ( page v ).
• Insert the video tape into the unit
Your monitor should now display a camera image. A Time/Date stamp displays on the
monitor with its factory default setting. A flashing message displays:
Set Clock
.
If you wish to program the Time/Date Display, see Time/Date Submenu on page 24 . A
step-by-step description is covered in that section.