60
Operating manual
ARCPULL 700
Translation of the original
instructions
10.3.2. WELDING CYCLE
0 V
0 V
0 V
0 V
0 V
24 V
24 V
24 V
24 V
24 V
ACTIVE
CONNECT
READY
CONTACT
TRIGGER
ARC_ON
duration ≥ Pre-Gas
duration ≥ Post-Gas
1
1
2
machine in motion
machine in motion
machine in motion
machine in position
machine in position
Activating PLC control
Bringing the accessory into contact with the support sheet
Starting the welding cycle
End of welding cycle Start of rest cycle
End of rest cycle Machine ready to weld
Bringing the accessory into contact with the support sheet
Starting the welding cycle
Trigger not taken into account because : - the machine is in rest cycle - the gun is still on the previous weld spot
Note 1: When CONTACT is detected, you must wait for a period of time at least equal to that of the Pre-Gas phase
(see § 9.3.4) before starting the welding cycle. Also, before the gun is disconnected, you must wait for a period of time
at least equal to that of the Post-Gas phase once the welding process is finished.
Note 2: Once a welding cycle has been completed, the gun must be released from the consumable and
must not come into contact with the support sheet until the machine is no longer in the resting phase
(READY means the machine is back to 24 V).