EN
33
Operating manual
ARCPULL 700
Translation of the original
instructions
1. WARNINGS - SAFETY REGULATIONS
GENERAL INFORMATION
These instructions must be fully read and understood before operating the machine.
Do not carry out any modifications or maintenance work that is not included in the user manual.
The manufacturer shall not be liable for any damage to persons or property caused by use that does not comply with the instructions in this user
manual.
If you have a problem or query, please consult a qualified technician to set up the device correctly.
THE ENVIRONMENT
This equipment should only be used for welding operations within the limits indicated on the rating plate and/or in the user manual. The safety
regulations must be observed. In the event of improper or dangerous use, the manufacturer shall not be held liable.
The device must be set up and operated in a location that is free of dust, acids, flammable gases and other corrosive substances. The same applies
to the device’s storage. Make sure there is sufficient air circulation when in use.
Temperature ranges:
Use between -10 and +40°C (+14 and +104°F).
Store between -20 and +55°C (-4 and 131°F).
Air humidity:
Less than or equal to 50% at 40°C (104°F).
Less than or equal to 90% at 20°C (68°F).
Altitude:
Up to 1,000 m above sea level (3,280 feet)
PROTECTING YOURSELF AND OTHERS
Arc welding can be dangerous and cause serious injury or death.
Welding exposes people to a dangerous source of heat, light and radiation from the arc as well as electromagnetic fields (a warning to those with
pacemakers), risk of electrocution, noise and gaseous fumes.
To protect yourself and others, follow these safety instructions:
To protect yourself from burns and radiation, wear insulating, dry, fireproof clothing in good condition without lapels; the clothing
must cover the whole body.
Wear gloves that provide electrical and thermal insulation.
Wear a mask or goggles with a shade tint between 5 and 9. Protect your eyes during cleaning operations. Wearing contact lenses
is strictly forbidden.
It is sometimes necessary to enclose the welding area with fireproof curtains to protect it from arc radiation, spatter and incandescent
waste.
Inform people in the welding area not to look at the arc rays or the molten parts and to wear the appropriate clothing to protect
themselves.
Wear noise-cancelling headphones if the welding process reaches a noise level above the permissible limit (these must be worn
by anyone in the welding area).
Keep hands, hair and clothing away from moving parts (the fan).
Never remove the cooling unit’s protective casing when the welding power source is on; the manufacturer cannot be held responsible
in the event of an accident.
Newly welded parts are hot and can cause burns when handled. When carrying out maintenance on the torch or electrode holder,
make sure that it has sufficiently cooled by waiting at least 10 minutes before starting any work. The cooling unit must be switched
on when using a water-cooled torch to make sure that the liquid does not cause burns.
It is important to secure the work area before leaving it, this is to protect people and property.
WELDING FUMES AND GASES
The fumes, gases and dusts emitted by welding are health hazards. Sufficient ventilation must be provided and an air supply may
be required. An air-fed mask could be a possible solution if there is inadequate ventilation.
Check that the extraction system is operating effectively by checking it against relevant safety standards.