4
DENT PULLING INDUCTOR
EN
This manual contains safety and operating instructions. Read it carefully before using the device for the first time and
keep it in a safe place for future reference.
This inductor is compatible with your 2.4 kW induction heating system (version 2 or above). To check
the version of your product, turn it off and on again with the ON/OFF switch. For 2 seconds, the version
will be displayed:
- 2XX (compatible)
- 1XX (not compatible)
To update your product to version 2 or above, you will need to change the command electronic board.
Contact your dealer or distributor.
DESCRIPTION
The dent pulling inductor has been designed for paintless dent repairs on car bodies e.g dents made by hail stones. It
is not necessary to clean the reverse side in order to restore the surface. Only the exterior is affected.
Warning ! Although the dent pulling inductor stays cold, prolonged heat on the car body might
damage the paint. JBDC accepts no responsibility for damages caused to your vehicle due to misuse.
PRINCIPLE
The dent pulling inductor facilitates the elimination of dents using a thermal expansion of the metal sheet. When placed
on a dent, the inductor will heat the metal between the 2 inductor feet. The surrounding cold metal maintains the
heating part in compression. The heat on the sheet will provide a suction in the direction of the inductor, removing the
initial dent.
Heating
point
AUTOMATIC MODE
In this mode, heating power is limited to 0.5 seconds to avoid burning the paint. The heat is controlled by pressing the
accessory button. Be aware that repetitive pressing, without moving the inductor may result in burnt paint. If heating is
required in the same place on the car body, we advise leaving the sheet metal to cool.
1 Press
>2 Press
OK
