GVD M1184, Быстрый старт

Страница: 33 / 54

Mobile NVRs M1184 / M1284 Quick Start Guide
27
Select Ignition Power Mode
The mobile NVR features an on-
board rotary switch to control the
ignition power. Follow the guide
below to use the rotary switch to
tune the ignition power feature:
To access this rotary switch,
simply open the mobile NVR
and access the motherboard as
described in Access Motherboard
on page 11 . Then use a hand
tool such as a flathead screwdriver
to modulate the rotary switch to a
mode you desire.
Tune to mode 0~6 to apply the
power-on/off delays as tabulated
in the
right.
Mode PWR on/off Feature Remark
Mode 0
(default)
Power-on delay N/A
Power-off delay N/A
Hard-off timeout N/A
This is the ATX mode without power on/off delays.
When this mode is enabled, you can only use the
power button on the front panel to turn on/off the
mobile NVR.
Mode 1
Power-on delay N/A
Power-off delay N/A
Hard-off timeout N/A
This is the AT mode. When enabled, the system
auto turns on when DC power is applied. However
the system will try to repeat the power-on cycle if
the system failed to boot to OS.
Mode 2
Power-on delay 10 sec.
Power-off delay 10 sec.
Hard-off timeout 10 min.
Modes 2 to 5 feature a variety of power-on/off
delays. And each supports a hard-off timeout of 10
minutes.
Mode 3
Power-on delay 30 sec.
Power-off delay 1 min.
Hard-off timeout 10 min.
Mode 4
Power-on delay 30 sec.
Power-off delay 5 min.
Hard-off timeout 10 min.
Mode 5
Power-on delay 30 sec.
Power-off delay 30 min.
Hard-off timeout 10 min.
Mode 6
Power-on delay 30 sec.
Power-off delay 2 hr.
Hard-off timeout 10 min.
This mode features a very long power-off delay
and "smart off-delay", which auto-detects system
status during the power-off delay to cut off the
system power if the system powers off before the
power-off delay expires.
The
rotary
switch