mega macs 56 Bike
7.4.6
Basic settings
Here you can adjust or adapt components and ECUs according to manufacturer's specifications.
7.4.6.1
Preconditions for Basic Settings
Regard the following in order to perform basic settings:
•
Vehicle system is working properly.
•
No trouble codes saved in ECU memory
•
Vehicle-specific preparations performed.
7.4.6.2
Performing Manual Basic Settings
WARNING
Wrong or incorrectly performed basic settings
Risk of injury or material damage to vehicles
Regard the following when performing basic settings:
•
Select the correct vehicle type.
•
Regard the window with infos and instructions.
Proceed as follows to perform the manual basic setting:
1. Perform steps 1 to 10 as described in the section
CAUTION
Rolling of vehicle
Risk of injury or material damage
Proceed as follows before starting:
1. Prevent the vehicle from rolling.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
2. Insert the DT VCI into the vehicle's diagnostic connector.
Both LEDs of the DT VCI flash. The DT VCI is ready for operation.
3. Select
Diagnostics > Function > Basic settings
.
NOTE
The selection of the following possibilities depends on the selected manufacturer and vehicle
type:
•
Functions
•
Assemblies
•
Systems
•
Data
73
