GTS DWG (BL) 13/7-2 ZE, Инструкция по установке и эксплуатации

Страница: 29 / 88

Page 29 Issue 07/2011
Installation of generator
General provisions for installation
The drive system must have sufficient power reserves for the dynamic
processes when switching electrical consumers on and off. Its control system
must have reliable command over these processes..
Do not change the constructive form and design of the generator.
Mounting surfaces must be precisely flat. Avoid alignment errors during
assembly.
After assembly, a test finger as per EN 60034, Part 5, or a foreign particle
more than 12 mm diameter (e.g. balls) must not be able to touch rotating
parts when this would lead to a hazard. In particular, the safety devices of the
power transmission system must be sturdily built and securely assembled.
Safety devices must only be removable with a tool.
The cooling air must be supplied and discharged so as to reliably dissipate
the arising heat loss. Only non-harmful quantities of dust and water may be
drawn in with the cooling air. Avoid short circuits in the airflow.
Observe the specific installation instructions and regulations for the
individual generator types.
Do not operate generators with a second shaft end without a properly
assembled working machine or protective covering.
Install suitable safety devices for protecting circuits (power sockets) against
short circuit and overcurrent in an external switch cabinet for generators
without a factory-installed switch box that contains electrical safety devices
and power sockets. The neutral conductor N must be secured. Coordinate
the type and nominal current of the protective circuit breakers with the
generator manufacturer GTS. For more information
ð chapter xxx, page xx.
For generators without factory-installed switch box that contains electrical
safety devices and power sockets, check the generator, the switch cabinet
and the complete electrical installation in accordance with DIN VDE 0100,
Part 610, by visiting, testing, and measurement before initial commissioning.
y Generators of model 132: Installation ð section 3.5, page 31.
y Generators of model 160: Installation ð section 3.6, page 42.