GTCO CalComp Super L VI Series, Руководство пользователя

Страница: 12 / 48

Super L VI 12
The menu button initiates Select Mode. Two-digit numeric codes are entered after
Select Mode is activated.
NOTE: The Select Mode will not work with the USB interface. USB digitizers are used
exclusively with Wintab drivers.
Most software supports Wintab using the TabletWorks drivers, whose
SuperSet Code
is
on the SuperSet Menu. The Super L VI comes from the factory with the
SuperSet Code pre-configured.
The button toggles the digitizer alarm OFF or ON. The button tests the digitizer grid
in the Active Area.
When using the SuperSet Menu, a tone will sound indicating a successful selection when you
click on the button. Four tones will sound when you select the button. (See the
Super L VI Tones
section for a complete table of the Super L VI tones.) The number buttons
through are active only after clicking on the button to activate Select Mode.
Resetting Super L VI
The Super L VI can be reset by:
 Turning off the power switch on the Controller Connector Panel
 Unplugging and re-plugging the power supply
 Clicking on the SuperSet Menu.
When one of these events occurs, the Super L VI will revert to the configuration that was last
defined. Any remote commands that were active before the reset will be lost.
Turning the Alarm Off and On
You can disable the alarm if you do not want to hear a tone each time the transducer button is
pressed. When the alarm is off, you will still hear diagnostic and menu-related tones.