GTCO CalComp Drawingboard IV, Руководство пользователя

Страница: 29 / 46

DrawingBoard IV 29
To return to the default frequency, repeat the above process. When you replace the cursor
batteries, the cursor is automatically reset to the default frequency.
Changing the Frequency of the Cordless Pen
Press both side buttons and the tip simultaneously and hold for approximately three
seconds.
To return to the default frequency, repeat the above process. When you replace the pen
batteries, the pen resets to the default frequency.
Changing the Frequency of a Pointing Tool
You must use the Menu Strip to change the frequency of the corded transducers (see the
Setting corded frequency option in the Tablet Options section).
Tablet Checklist
 Is the tablet power supply plugged into the serial connector and into a live outlet?

Is the tablet power switch on?
 Does the power light glow steadily when the pointing tool is inside the drawing
area? Does it blink when the pointing tool is outside the drawing area?
 The power light will blink if the pointing tool has gone into sleep mode. Press any
button on the tool to activate it. If the power light continues to blink and the
pointing tool is in the drawing area, change the pointing tool’s battery.

Are all cable connections tight?

Power cable to serial connector?

Pointer cable to tablet?

Serial cable to tablet?

Serial cable to computer? Check that the cable is connected to the serial port
specified in your software package.

Is the tablet set up according to the software recommendations?

Are any of the connector cables or receptacles damaged? Check for bent pins, cut
insulation and loose wires.
Computer Checklist
 Is the computer plugged into a live outlet? Did you turn on the computer?

Does the computer work with any of your software? Try one of your other
programs. If the computer has a diagnostic diskette, use it.

Is your software package installed correctly?