GTCO CalComp Drawingboard IV, Руководство пользователя

Страница: 12 / 46

DrawingBoard IV 12
Selecting a Pre-Programmed Setup
There are three pre-programmed setups available with DrawingBoard IV:

GTCO CalComp by Turning Technologies DP5 High Resolution Binary

Summagraphics MM 1201
 CalComp 2000 ASCII
These setups are commonly used within software applications as required tablet formats.
They are stored in Save Areas
Default , 2 and 3 , respectively. Check the manual that came
with your software package to see if your application requires one of these pre-
programmed setups. The
Default setup is available when you power on the digitizer.
To select one of the other setups:
1. Turn on Configuration Mode by clicking on the Config/Exit key.
2. Click on the desired Restore key.
3. Click on the Config/Exit key again to exit Configuration Mode. The new
setup is activated.
The following table lists the tablet options used by the pre-programmed setups.
Default Save 2 Save 3
Mode Run Track Point
Baud Rate 9600 9600 9600
Data Bits 8 8 7
Parity None Odd Even
Data Rate 125 pps 150 pps 125 pps
Resolution 1000 lpi 500 lpi 200 lpi
Output Format Format 23 Format 30 Format 0
Emulation GTCO TTech DP5
High Resolution
Binary Summagraphics
MM 1201 Binary CalComp 2000
ASCII