GT POWER GT200W, Руководство по эксплуатации

Страница: 6 / 40

GT200W
PROFESSIONAL WELDER GENERATOR
6. 7. www.gtpower.co.nz www.gtpower.co.nz
Safety
Read this entire installation section before
you start installation. More information on
safety procedures at the rear of this manual.
General Operation
The GT200W is designed for commercial use
welder/generator applications. As a welder
it provides 200A of DC constant current for
welding with DC stick electrodes. A single dial
lets you select a full range of welding output
from 50 to 200A.
As a generator it can supply up to 5500 surge
watts or 5000 continuous watts of 230 volt,
single-phase AC power. The machine is port-
able.
Recommended Applications
WELDER: The GT200W provides excellent
constant current DC welding output for stick
(SMAW) welding.
GENERATOR: The GT200W gives smooth
AC generator output for continuous auxiliary
power usage within the engine manufacturerʼs
required maintenance recommendations.
Operational Features & Controls
The GT200W was designed for simplicity.
Therefore, it has very few operating controls.
The welder/generator automatically senses
whether generator or welding function is re-
quired. No manual change is needed.
The gasoline engine controls include a recoil
starter, choke and stop switch. See the EN-
GINE OPERATION section of this manual for
details about starting, running, stopping, and
breaking in the gasoline engine.
Design Features & Advantages
• 200A DC constant current welding for
stick electrodes.
• Lightweight / portable.
• Full range, continuous welding output
control with a single knob.
• Five function hour meter.
• 5500 Surge Watts or 5000 Watts of
continuous 230V single phase AC
auxiliary power.
• Powerdyne 14HP overhead valve air-
cooled gasoline engine. Smooth running,
long life.
Welding Capability
The GT200W is rated at 180A, 26VDC at
60% duty cycle on a ten-minute basis. This
means that you can load the welder to 180A
for six-minutes out of every ten-minute pe-
riod. The machine is capable of higher duty
cycles at lower output currents.
The current is continuously variable from 50 to
200A DC. The GT200W can, therefore, weld
with 1.6, 2.5, 3.2, 4.0 and 5.0mm diameter
electrodes.
Limitations
• The GT200W is not recommended for
any processes besides those that are
normally performed using stick welding
(SMAW) procedures.
• The GT200W is not recommended for
pipe thawing.
• The generating function is never to be
used while welding is in process.