GT POWER GT200W, Руководство по эксплуатации

Страница: 16 / 40

GT200W
PROFESSIONAL WELDER GENERATOR
16. 17. www.gtpower.co.nz www.gtpower.co.nz
CAUTION:
Welder and Generator MUST NOT be in
use simultaneously.
NOTE: You can supply multiple loads as long
as the total load does not exceed 5500 peak
watts or 5000 continuous watts. Be sure to
start the largest loads first.
AWS
CLASSIFICATION:
E6010
E6011
E6011
E6013
E7018
E7018
E7018-17 & E308L-17
ENi-CL
ELECTRODE
POLARITY:
CURRENT RANGE (AMPS):
2.5mm 3.2mm
4.0mm
DC+
DC+
DC+
DC±
DC+
DC+
DC+
DC+ 50 - 75
50 - 75
50 - 80
70 - 95
70 - 100
65 - 85
50 - 80
50 - 80
75 - 135
70 - 110
55 - 110
100 - 135
90 - 125
90 - 125
75 - 110
80 - 110
-
80 - 125
105 - 125
-
125 - 145
-
80 - 125
-
SHEET THICKNESS: 3.2mm and thinner
3.2mm and thicker
Electrode
Selection Guide
For example, a device rated 230V, 10A will
need 2300W of power (230 x 10 = 2300).
You can use the Power Applications table on
the following page, to determine the wattage
requirements of the most common types of
loads you can power with the GT200W Be
sure to read the notes at the bottom of the
table.
Using the GT200W as an Auxiliary
Power Supply
1. Start the gasoline engine. (See Engine
Operation earlier in this manual)
2. Set the Welder / Generator mode to
Generator
3. Plug load(s) into the 230V power receptacle.
There is no need to switch the machine to
“welding mode” as the machine automatically
detects which process is being used.