GT POWER GT200W, Руководство по эксплуатации

Страница: 15 / 40

GT200W
PROFESSIONAL WELDER GENERATOR
14. 15. www.gtpower.co.nz www.gtpower.co.nz
After Finishing the Weld
1. Stop the gasoline engine.
(See Engine Operation in this manual)
2. Allow the electrode and work to cool com-
pletely.
3. Remove the work clamp from the work.
4. Remove any remaining piece of electrode
from the electrode holder.
5. If you have finished using the GT200W
for welding, disconnect the welding ca-
bles from the weld output terminals.
For DC+ welding, the electrode cable is to be
connected to the “+” output socket and work
cable to the “-” output socket. (For DC- weld-
ing, reverse these connections.)
The GT200W can deliver from 50 to 200A of
welding output current. Output can be adjust-
ed by setting the current control dial on the
output control panel.
You can get maximum welding output by set-
ting the dial to 200A. At high current settings
like this, some output may decrease as the
machine is used. If you are welding for a long
time, you may need to turn the dial slightly
upward to maintain the same results.
The numbers on the dial correspond to the
approximate amps needed to weld using ge-
neric welding rods. The Electrode Selection
Guide in this manual gives the recommended
dial settings based on the thickness of the
work and the size and type of rod used.
To Use the GT200W for Welding
1. Insert, push and turn connectors on weld-
ing cables into the respective sockets on
the welding machine. Make sure they are
firmly locked in place. (There is no need
to switch the machine to “welding mode”
as the machine automatically detects
which process is being used.)
CAUTION:
DO NOT attempt to use welding pro-
cess and power generation process at
the same time.
2. Select the appropriate electrode. (See
Electrode Selection Guide Table in this
manual).
3. Attach the work clamp securely to the
work you are welding.
4. Insert the electrode into the electrode
holder.
5. Set the current control dial to the desired
output current.
6. Start the gasoline engine.
7. Strike an arc and begin welding.
Auxiliary Power
Operation
WARNING:
Be sure that any electrical equipment
plugged into the generator AC power
receptacles can withstand a ±10%
voltage and a ±5% frequency variation.
Some electronic devices cannot be
powered by the GT200W. (Refer to the
Generator Usage Table in this manual)
General Information
The GT200W is rated at 5500 peak watts or
5000 continuous watts. It provides 230V of sin-
gle phase power, up to 23.91A from the single
outlet/adapter cord. Rated continuous amper-
age use is 21.7A.
Electrical loads in watts are calculated by
multiplying the voltage rating of the load by
the number of amps it draws. (This informa-
tion is given on the load device name plate.)