GSi PNEG-1295, Руководство по установке

Страница: 45 / 52

6 x 6 Distributor Platform
45 PNEG-1295 16" - 36" Platforms
This assembly is designed to be located at any
elevation on trunking that’s needed to provide
access to other equipment. Determine
elevation of platform surface and work from
there. Locate all parts required for assembly
by using the charts shown in the following
figures.
Locate all clamp halves, clamp brackets,
threaded rods, and hardware to assemble
clamps onto the trunking. Measure the
distance between the clamps to assure proper
location for support channels and knee brace
attachment. See clamp detail for hardware
orientation. Place 5/8" nuts and lock washers
on a threaded rod (one from each end). Place
a clamp half on each end of the rod and thread
another nut and lock washer to hold clamp in
place. Now place that assembly around trunk
and place a clamp bracket onto the opposite
end of the clamp assembly and use
1/2" hardware to fasten parts together. Adjust
the position of the inside nuts of the rod
assembly to allow the clamps to be tightened
onto the trunking.
NOTE: TIGHTEN CLAMPS ONTO
TRUNKING, DO NOT OVERTIGHTEN AND
COLLAPSE THE TRUNKING. Position inside
nuts back to the clamp and tighten.
Platform Clamps
Figure 37