GSi Autoflow 2000 Series, Инструкция по эксплуатации

Страница: 42 / 55

2000 Autoflow
42
ELECTRICAL POWER SUPPLY
Four (4) control wires between the Autoflow Control
Box and the Wet Supply Rotary Switch.
Use 16ga wire for control wires.
ATTN: Use only MTW type wire for control wiring!!
Wet Supply Rotary Switch mounted in the side of the
wet grain holding tank.
Autoflow to Wet Supply Rotary Switch Interconnect
The 110V AC rotary switch located in the wet
storage tank is used to inform the computer on the
availability of wet grain. The Wet Supply Rotary
Switch use 110V AC to power the motor and 12V
DC + to switch a signal back to the computer. To wire the Wet Supply Rotary Switch to the
Autoflow Control Box do the following:
1) Run Four (4) control wires from the
Autoflow Control Box to the Wet
Supply Rotary Switch.
2) Connect the wires as shown in figure 21.
Figure 21