2
Initial Setup
Power Supply
12V DC
Current consumption
70mA
Current consumption with load (max)
100mA
Relay Contact Rating
5 Amps /240V ac
Operating Temperature
-20 C to +60 C
Moisture Resistance
IP 67
Dimensions - Flush Mount
W.
87mm
D.
21mm
H.
119mm
- Surface Mount
W.
87mm
D.
35mm
H.
119mm
Number of Users
20000
Technical Specs
Initial Installation
The Door Control should be Factory Defaulted after installation. This will restore all
default settings to the Door Control and will unenrol it from any existing GSD
Controller.
The Door Control will then start to scan and enrol on a GSD controller.
Refer to the section ‘Enrolling Door Controls’ on page 12 for instructions on how to
configure the GSD Windows Software.
Restoring Factory Settings:
Wi-Smart Pin
Step Description
1 Remove default link on back of the Door Control.
2
Replace the default link. The LED will turn amber after 5 secs, Remove
the link immediately to default the Door Control.
3
Initial Setup
Restoring Factory Settings:
Wi-Smart only
Step Description
1 Present Programming Card 2 Times
2
Present Any Card Once
Programming
Card x 2
AnyCard
x 1
Adding a Programming Card
Note: Add a progrmming card to the Door Control. The Door Control must
be disabled first if it has been enrolled onto a GSD Network Controller.
Follow the method below to add a programming card to the Door Control.
Adding a Programming Card
AnyCard
x 2
Step Description
1 Remove security caps and power down unit.
Power up unit and Present Any Card 2 times
2
immediately. This card is now the Programming
Card for the unit. Refit security caps
Factory Default PIN codes
The following PIN codes are the Factory Default Settings:
- The Default Engineer code is ‘6666’
- User PIN ‘1111’
Note: The User PIN ’1111’ is deactivated when the Door Control is enrolled
onto a GSD Network Controller.
