Grunbeck softliQ:MC, Руководство по эксплуатации

Страница: 43 / 80

Start-up
43 | 80
BA_TD
3-
BM
000e
n_
06
4_sof
tli
Q
-M
C
.docx
» The display indicates "Remaining time 22:00 min". The counter counts down to
00:00 min. If this is completed, the next display message will be indicated.
In exceptional cases, start-up may be aborted (remaining time runs down to
00:00 minutes and nothing else happens). In this case, proceed as follows:
► Disconnect the mains plug.
► Wait for 5 seconds.
► Start again from point 6.1.1.
Should, after some time, "raw water shut-off valve at connection block still
closed" appear in the display, open the shut-off valve for raw water.
14. Open the soft water shut-off valve.
15. Confirm with ▼.
16. Check the water hardness on exchanger 1 as described in chapter 7.7.
» Upon confirmation with ENTER, exchanger 1 is put out of operation and exchanger
2 is put into operation.
17. Check the water hardness on exchanger 2 as described in chapter 7.7.
18. Confirm with ▼.
With these tests, the function of the exchangers is checked. The water
sample must have a hardness of less than 1 °dH.
19. Use ▲ and ▼ to set the desired value for the soft water hardness.
• Recommendation for Germany: Soft water hardness 3 - 6 °dH.
• Recommendation for Austria: Soft water hardness at least 8.4 °dH.
Take the maximum admissible sodium concentration of your drinking water
into consideration (refer to chapter 13.2).
20. Press ENTER to start the test regenerations.
» The remaining time will be indicated in the display. The remaining time for the
regeneration of both exchangers is counted down.
The test regenerations take approx. 33 minutes for both exchangers.
In exceptional cases, a malfunction may be indicated at the end of the test regeneration. In
this case, proceed as follows:
► Confirm with ENTER.
► Restart the start-up program.
► Call Grünbeck's technical service/authorised service company if the malfunction
occurs again.