18
5.3 Commissioning
Mount LUB-V carefully according to the steps described in chapter 5.2. Depending on the
scope of delivery you must also carry out the following additional measures for first-time
commissioning:
1. Mechanical fastening
Fix LUB-V mechanically. Pay particular attention to the maximum tightening torques.
2. Electrical connection
Connect LUB-V with an external power supply system (e.g. PLC) by adding a proper
connecting cable to the electrical interface on the side of LUB-V.
3. Check the assembly
Make sure that LUB-V is assembled properly and completely. In particular, the external
power supply system has to be connected and a lubricant cartridge must have been
fitted.
4. Power on
If you want to put LUB-V into operation, switch on LUB-V. LUB-V only delivers lubricant to
the lubrication point according to the settings when switched on. The detailed description
for powering on can be found in chapter 6.3.3.
5. Execute FIL function
Execute the FIL function. The detailed description can be found in chapter 6.3.9. LUB-V
performs a certain number of strokes and transports lubricant from the cartridge to the
outlet.
6. Hydraulic connection
Connect the consumer hydraulically to LUB-V. If you connect tubes to LUB-V make sure
that tubes and connectors are installed tightly, cleanly and correctly.
Ideally, use tubes prefilled with the appropriate lubricant.
7. Check the settings on LUB-V
Check the required values for the lubrication point at the factory settings of LUB-V and
adjust them if necessary. Changes at LUB-V can be made in PRO menu, chapter 6.3.7.
