GrowSpan Gothic Pro 106314R, Инструкция по эксплуатации

Страница: 36 / 57

GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
36
Revision date: 05.29.19
INSTALL ROLL-UP PANELS
This model includes a roll-up side panel for each side of the
greenhouse. The panel film material is typically shipped as
a single, 6' roll. Complete the following steps:
1. Locate the roll of side panel for the roll-up sides and
cut a length from the roll that is the length of the
greenhouse plus two (2) feet.
2. Stretch the roll-up panel out along the side of the
greenhouse and center it from end-to-end.
3. Using the upper channel of the double U-Channel and
the wire spring, secure the top edge of the film in the
channel.
4. With the top edge secured, spread the free end of the
panel out so that it hangs evenly from the secured
edge.
5. Continue with the following roll-up procedures.
Photo are used for illustration purposes only. Frame shown
may differ from actual frame.
ASSEMBLE THE ROLL-UP SIDE CONDUIT
Gather the parts:
• Pipe 1.315'' x 75'' swaged 17 GA (#131S0075)
• Pipe 1.315'' x XX'' plain 17 GA (#131P0XX)
• Tek screws (#FA4482B)
The roll-up side conduit assembly is attached to the bottom
of the roll-up side cover material. This assembly runs the
length of the frame and serves as the center pipe that the
roll-up cover wraps around when it is opened to ventilate
the shelter. This conduit is identical to the purlins that were
assembled and attached to the frame.
NOTE: The number of pipes used in the roll-up conduit
assembly varies with the length of the greenhouse.
Roll-up conduit assemblies consist of multiple sections of
swaged 1.315" pipe at 75" in length (part #131S075) and
one (1) additional plain 1.315" pipe at a shorter length
(part #131P0XX) determined by the greenhouse, where
XX represents the remaining length required to complete
the roll-up conduit assembly and to reach the end of the
greenhouse.
Complete these steps to assemble the roll-up side conduit.
1. Locate all sections of pipe needed to assemble the
cover conduit.
2. Insert the swaged end of each pipe into the plain end of
another pipe until the conduit is assembled.
3. Secure each pipe joint with a Tek screw and tape over
the screw using duct tape.
4. Place the assembled conduit at the base of the rafters
along the outside of the greenhouse.
5. Repeat the steps to assemble the remaining cover
conduit.
6. Continue with the procedure that follows to attach the
conduit to the roll-up side panels.