GrowSpan Gothic Pro 106314R, Инструкция по эксплуатации

Страница: 21 / 57

21
GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
Revision date: 05.29.19
H-Channel
Installed End Panels
with H-Channel
NOTE: When attaching any profile, remember to
account for the areas where different sections of profile
intersect so that the profile is cut to the proper length.
Space the screws evenly at 16" when securing the
panels. DO NOT USE WASHERS WHEN SECURING
THE H-CHANNEL TO THE END WALL FRAMING.
The H-channel can be installed before the panel is
attached to the framing or after securing the panel to
the frame.
DO NOT install profile on the bottom of the end wall
panels. These edges are sealed with the white vent
tape.
Upper Panel
In this photo, the top of the panel is removed using a
power tool equipped with a round cutting bit. A utility
knife can also be used.
3. Place the panel in position, attach it to the end wall
framing using Neo-bonded washers and the long Tek
screws.
4. Continue installing the polycarbonate panels as
described for the front and back end walls.
ATTENTION: U-channel profile is installed along the
edges of the panels shown in the diagram below.
Frame shown above may differ from actual frame.
5. Continue with the
Double Door Assembly
procedures
that follow.
END PANEL INSTALLATION (continued)
The greenhouse in this photo is used for illustration only. It is
of a different model.
Cut upper panel
to proper length.
DOUBLE DOOR ASSEMBLY
The materials and parts needed to assemble the doors
include:
• Door frames and polycarbonate panels
• Door hinges and latch hardware
• Aluminum U-Channel profile (#104213)
• End cap profile (#104548)
• Tek screws (#FA4482B & FA4484B))
• Neo-bonded galvanized washers (#102921B)
ASSEMBLE AND ATTACH THE DOORS
NOTE: Install the polycarbonate panels with the UV-
protected side to the outside.
1. Locate door frame (102923), assemble (if needed), and
place on a flat surface.
2. Select one polycarbonate panel (this will be one 4' x 8'
panel) and trim it so that the length is one-quarter inch
(1/4") shorter than the length of the door frame.
3. Trim width of panel (if needed) so that it is one-quarter
inch (1/4") narrower than width of door frame.
NOTE: Trimming the panels as instructed will keep the
panel flush with the edge of the door frame after the
aluminum profile is installed.
4. Center the panel on the door frame.
Install profile here.
Ground Level