GrowSpan Gothic Pro 106314R, Инструкция по эксплуатации

Страница: 26 / 57

GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
26
Revision date: 05.29.19
There are different ways to install polycarbonate roof panels. Individuals familiar with the installation of these panels and
overall assembly of similar greenhouses may choose to install according to past experience. Since there are differences
between buildings, read through the procedure that follows to better understand panel installation for this greenhouse.
X
Mark here
POLYCARBONATE ROOF PANELS
This procedure describes one way to install panels.
Complete these steps:
1. Take one 116049 panel (47-1/4" x 96"), mark UV-
protected side, and remove protective film.
NOTE:
Mark UV-protected side using a piece of tape or
other means to ensure side is installed toward the sun.
2. Apply vent tape (104774) to cover one end of panel.
3. Move to opposite end of panel and cover open cells
using DH8007 foil tape.
NOTE: Panel end with vent tape is the bottom; panel
end capped with foil tape is the top.
4. Place panel on a covered surface and install 111928
H-channel (8') along both sides .
Install UV-protected
surface toward the sun.
Tape
NOTE: If needed, use a thin bar or putty knife to
carefully pry H-channel open for easier installation. Use
a rubber mallet to gently tap H-channel into place along
each panel side. Do not damage channel or panel.
5. After panel is prepared, carefully lift and move panel to
first bay at one end of assembled frame.